Question / Help Fighting BSOD

Magnethead said:
Still windows 7 professional x64. The sabrent x64 driver is what was BSODing, i found the x32 driver and this is what I have now.

I don't have OBS and yawcam open together. I close one and open the other (I know 2 programs cant use one camera). Boggles me that yawcam can access the video but OBS can't.

Related note- sometimes when i select the sabrent device, a little read box appears in top left corner, sometimes it doesn't. right clicking to fill screen doesn't change anything.
Click to expand...
red screen usually means something is not working right with the settings or device. sometimes resolution, sometimes fps sometimes that card just doesnt work (in this case we know that isn't it).
 
dping said:
red screen usually means something is not working right with the settings or device. sometimes resolution, sometimes fps sometimes that card just doesnt work (in this case we know that isn't it).
Click to expand...
It's not a red screen. It's just a red square like for the resizing tool. But only in that one corner. Sometimes it's there, sometimes it isn't. The audio stream from the sabrent is working no problem.
 
Magnethead said:
It's not a red screen. It's just a red square like for the resizing tool. But only in that one corner. Sometimes it's there, sometimes it isn't. The audio stream from the sabrent is working no problem.
Click to expand...

red is red, if its a small square it might be having trouble detecting the resolution.
 
dping said:
red is red, if its a small square it might be having trouble detecting the resolution.
Click to expand...
That's what I was thinking. Stretch to screen didn't work, and under configure properties, it says 525 lines detected.

OK, so if I remove all sources from the current project, close OBS, reopen OBS, and add the sabrent card as the first source, it will show video. If I open OBS with another project set up, remove those sources, and add the sabrent, it's still black. I have to add it as a new source as the first source in a new session.
 
This is what I'm getting every now and then for the sabrent capture device and even the onboard webcam as shown here.

Also shown is why I want to use this camera..may only be composite video out, but that's window screen at 37x optical zoom and manual focus. Lens is a 3-96mm F2.6 piece.

onboard-webcam.png


zommed-in.png
 
dping said:
I couldn't tell you which ones specifically work and dont. I just know about that Hauppauge was only implemented in OBS MP.
Click to expand...
OK. Well, we shall find out tomorrow.

The express card may not even work, I guess the USB 3.0 needs to be on the main buss to have full 3.0 bandwidth and support, i dont know if the smart card slot is connected like that on mine.
 
Hauppauge USB Live 2 (Hauppauge Cx23100 device) Came in.

It does the same thing that the sabrent card does. When i close and reopen OBS, I lose the video input but audio is still there. If i close again and reopen, video comes back. So now it's intermittent rather than all the time. Which I will take as an improvement.
 
Last edited:
I spoke too soon. Now the hauppauge won't pull up at all, even adding as the first source in a new session. Both lights are lit up like it's actively grabbing data, but screen is blank. Going to make a new thread over in the MP section.
 
Last edited:
Magnethead said:
I spoke too soon. Now the hauppauge won't pull up at all, even adding as the first source in a new session. Both lights are lit up like it's actively grabbing data, but screen is blank. Going to make a new thread over in the MP section.
Click to expand...
I wonder if your Usb ports are going to sleep. Check power in windows set it to high performance
 
You must log in or register to reply here.
Back
Top