rockbottom
Active Member
Doesn't matter, nothing on the receiving end, no transmission, no wasted bandwidth. Try using OBS in Studio mode, you might get lucky.
- Thread starter Palakis
- Start date
I already use OBS in Studio mode. I performed more tests to try to isolate the cause of the problem and realized that it only occurs when I use the window capture source. It doesn't happen when I use the screenshot source or capture device. It is as if obs disables window capture when the scene is not active. There is an option to disable some fonts when they are not active, however there is no for window capture source.
rockbottom
Active Member
Cool, that was easy. Nothing broke, nothing to fix.
tlv1studios
New Member
Is there a way to uninstall this add-on for Mac? What files and folders were used and should be removed?
Thanks!
Thanks!
Add the first scene to the second scene and place it on the bottom layer. It won't show up in the preview and the Zoom stream will continue.
Jaybonaut
Member
What do you use for Sync settings now, Network or Source? Does it make a diff? What about Latency mode, Normal or Low?
Acey05
Member
Normal didn't have the Stutter or Audio "pops", and Network was the best option if both PC's aren't time synced since, as the name implies, it's using your Network to time the Sync. This is/was the best options.
However, currently Source Time with Low Latency since for a while OBS and NDI where a nightmare to run (the desync was almost instant, it constantly stuttered, had to reset my router after every stream, starting a new software would stagger the whole stream and required restarting OBS) and stuck with it for now.
I haven't tried going back because I don't know how well they will work.
You can try recording something small on the second PC for a couple of minutes, you might get lucky and it works for you perfectly.
PS: You can try Output Filters, those bypass most issues but they require extra power on your second PC and a very good Network system, otherwise OBS/NDI will disconnect your second PC from the internet constantly.
However, currently Source Time with Low Latency since for a while OBS and NDI where a nightmare to run (the desync was almost instant, it constantly stuttered, had to reset my router after every stream, starting a new software would stagger the whole stream and required restarting OBS) and stuck with it for now.
I haven't tried going back because I don't know how well they will work.
You can try recording something small on the second PC for a couple of minutes, you might get lucky and it works for you perfectly.
PS: You can try Output Filters, those bypass most issues but they require extra power on your second PC and a very good Network system, otherwise OBS/NDI will disconnect your second PC from the internet constantly.
Jaybonaut
Member
So Network and Normal are your recommendations, even though they still stutter. When you mentioned Output Filters, are they fixing the issues you mentioned with source and low or do you mean the microstutters a person sees on Network and Normal?
Acey05
Member
Network and Normal would be my recommendations, but I don't know how they work now or if they got fixed (tried them last time about 8 months ago).
Output Filters fix everything, but they require a strong "Network" (your router for example, or cables need to support the data being sent) and a strong PC (Filters are between 10-40% more expensive to render), because otherwise your "encoding" PC will keep on dropping the Internet Connection constantly every 30 minutes or so.
Output Filters fix everything, but they require a strong "Network" (your router for example, or cables need to support the data being sent) and a strong PC (Filters are between 10-40% more expensive to render), because otherwise your "encoding" PC will keep on dropping the Internet Connection constantly every 30 minutes or so.
Jaybonaut
Member
Where can I get these filters you recommend?
Finally, NDI replacement is complete as I've found a way to substitute the mirrored confidence monitor via HDMI and I can at last remove the NDI plugin. Handily, this has also freed up a lot of processing power.
The NDI plugin was super useful in the beginning but as the rest of the OBS software moved on and the NDI plugin didn't it certainly created more problems for me (especially the lack of NDI-HX and increasing network demands) but I very much appreciate the great amount of work the author did in bringing this plugin into existence so NDI could be used with OBS in the first place.
Cheers.
Jaybonaut
Member
...or perhaps you can redirect me to where I can learn more about these filters?
prestonality
New Member
Looks like OBS 28 RC1 doesn't support the current NDI plugin. Are there plans to update it?
Claudio Nunes
New Member
Friend,
do you have a forecast to update this excellent script, to be used in the obs 28 version?
do you have a forecast to update this excellent script, to be used in the obs 28 version?
Shuriken200
New Member
So does this mean that from V28 and onwards this plugin will be not usable at all for end users? (until updated that is) Since we need it for NDI to work at all with OBS?