I just had a strange experience - I could see audio from media sources in the meters, but nothing was output. It was recorded, but never sent to my monitoring device, even though Monitor & Output was enabled.
All the usual suspects were fine (monitoring device set, no reuse, no feedback). This persisted over reloads, nothing would fix it.
Then I changed the project sample rate from 48k to 44.1k -> restart = sound!
Then changed it back to 48k = still sound.
Very strange. Anybody seen this before, where something in the monitoring pipe seems to get stuck until the sample rate is (temporarily) changed?
All the usual suspects were fine (monitoring device set, no reuse, no feedback). This persisted over reloads, nothing would fix it.
Then I changed the project sample rate from 48k to 44.1k -> restart = sound!
Then changed it back to 48k = still sound.
Very strange. Anybody seen this before, where something in the monitoring pipe seems to get stuck until the sample rate is (temporarily) changed?