Hi,
I've a decklink setup with 4 POE cameras that's been working great until this morning. When I start OBS n of the camera will start working with n being 0-3 (I actually didn't get all 4 going). I'm on the latest release version. I did try winding back, but didn't get far due to incompatibilities with other plugins PTZ and downstream keyer.
Anyway, I looked at the log and there wasn't any errors etc. around the DShow setup. As a shot I updated the decklink drivers and AMD drivers, but neither did anything. The blackmagic viewer for the inputs all looked fine, so I'm guessing its something with OBS/Windows. I'd not consciously updated anything in windows/OBS since it was working.
Other than winding back, is there any other debugging I can do around this issue? I can grab the log, but it means a car drive as the machine is in another location.
Cheers
Jim
I've a decklink setup with 4 POE cameras that's been working great until this morning. When I start OBS n of the camera will start working with n being 0-3 (I actually didn't get all 4 going). I'm on the latest release version. I did try winding back, but didn't get far due to incompatibilities with other plugins PTZ and downstream keyer.
Anyway, I looked at the log and there wasn't any errors etc. around the DShow setup. As a shot I updated the decklink drivers and AMD drivers, but neither did anything. The blackmagic viewer for the inputs all looked fine, so I'm guessing its something with OBS/Windows. I'd not consciously updated anything in windows/OBS since it was working.
Other than winding back, is there any other debugging I can do around this issue? I can grab the log, but it means a car drive as the machine is in another location.
Cheers
Jim