Question / Help Not recording or streaming

NoDiceMike

NoDiceMike

New Member
I just downloaded 0.11.1 for OSX and I can neither record nor stream. I've searched and seen nothing to even point me in a direction for what the problem might be. Help please?
 
What happens when you try to record or stream? When you say you "can't", what exactly does that mean?
 
The issue seems to be the Sample Rate of 22.05 khz which isn't compatible with the CoreAudio AAC Encoder.
Set the Sample Rate to 44.1 khz in the audio settings of OBS and the issue should be solved.


(Tried it under Windows with CoreAudio and your settings and I'm getting the same errors.)
 
Gol D. Ace said:
The issue seems to be the Sample Rate of 22.05 khz which isn't compatible with the CoreAudio AAC Encoder.
Set the Sample Rate to 44.1 khz in the audio settings of OBS and the issue should be solved.


(Tried it under Windows with CoreAudio and your settings and I'm getting the same errors.)
Click to expand...

Hey! That did it!

Thanks so much for the help!
 
Hello, i'm having the same issue. OBS studio was working great for me about an hr ago and then i changed a few resolution settings on my elgato and now nothing. click stream or record and nothing happens. i looked at my sample rate and its set to 44.1 khz. please help
 
I'm also having a rough time trying to get OBS set up. It seemed to work fine yesterday, then just refused to record anything today. I have the log file here, if anyone can translate it for me.
 
Friskybizzz said:
Hello, i'm having the same issue. OBS studio was working great for me about an hr ago and then i changed a few resolution settings on my elgato and now nothing. click stream or record and nothing happens. i looked at my sample rate and its set to 44.1 khz. please help
Click to expand...
The Other Guy said:
I'm also having a rough time trying to get OBS set up. It seemed to work fine yesterday, then just refused to record anything today. I have the log file here, if anyone can translate it for me.
Click to expand...

Something that worked for me is I went into my settings and chose software x264 as my enocder instead of NVENC (or it could be something different in your situation.) You can change that setting in the output tab (atleast that is where it is for me, I use simple output mode.) Hope this helps!
 
You must log in or register to reply here.
Back
Top