I have a Shure SM7B that is first connected to a Rolls MS111 MicSwitch which I use to turn it on and off. Then from there the signal goes into a Cloudlifter. Then into the Microphone input 1 of the Scarlet 8i6. I route the signal to output to a speaker to hear. On OBS, I have this microphone signal as a separate sound input mono 1+2. I have a music feed using 3+4. Second stream in a row where, the microphone seemed to work all night (with me using the Rolls to shut it on/off) but at the very end just stops working. I can hear the mic through the speaker and I can see the levels in OBS moving as I talk, however no sound to the stream. The audio feed through 3+4 continues to work fine. Also, if I turn the Rolls off/on again the mic returns. Any advice what would be causing this?
Microphone Issues
- Thread starter BrianSTC
- Start date
konsolenritter
Active Member
That sounds really strange!!
Thru the speaker behind the Scarlet you could hear the mic all the time, but the rolls switch in front of all analog re-enabled it in the digital domain (between scarlet and pc)? oO
Even if you say that you could see the mics meter moving all the time. There must something be wrong. And if the sound reaches the pc (otherwise you would haven't seen the meters moving!) the problem must be in the digital domain alone. Doing the rolls switch shouldn't relate to it at all.
Do you have filters engaged in obs? Please (as usual)...
obsproject.com
Thru the speaker behind the Scarlet you could hear the mic all the time, but the rolls switch in front of all analog re-enabled it in the digital domain (between scarlet and pc)? oO
Even if you say that you could see the mics meter moving all the time. There must something be wrong. And if the sound reaches the pc (otherwise you would haven't seen the meters moving!) the problem must be in the digital domain alone. Doing the rolls switch shouldn't relate to it at all.
Do you have filters engaged in obs? Please (as usual)...
Please post a log with your issue! Here's how...
OBS Studio creates a log file each time you run it which contains very useful diagnostic information. Without a log file, it's much harder for any support volunteers to figure out problems and your post may be ignored. To upload a log file, go to the Help menu > Log Files > Upload Last Log...