This is an issue I have with OBS and my stream. It is all fine on the voice software I normally use - Mumble.
For example, I would like to point you to these two links:
1. http://www.twitch.tv/vulkkswtor/b/451832514 - at 1h15min10s I say something and the last word - smoking - was cut off on my stream, but was clearly produced and heard on Mumble)
2. http://www.twitch.tv/vulkkswtor/c/2815091 - at 0min48s my line ends with a " have a good night", which was heard on Mumble, but was cut off on my stream.
Can someone, please, give me directions what options I could or should change.
Here is what I am using in the AUDIO tab and MICROPHONE NOISE GATE tab:
* Push To Talk Delay - 0 (I suspect this is the right one I need to change, but description says it is for general delay, not for delay of end of speech after I release the PTT Key)
* Force Microphone to Mono - UNCHECKED
* Use PTT - CHECKED (key is insert, same as my Mumble PTT key)
* Mic Time Offset - 0
* Enable Noise Gate - UNCHECKED
* Attacktime - 50
* Hold Time - 200
* Release Time - 150
I could not understand to full the options in the last tab, but I don't also need to use noise reduction either.
I am using Push To Talk button. If any of these settings is related to the time delay for when sound cuts off after I release the PTT, then please tell me which one is it. For example, on Mumble I am using 1000ms "Hold Time" so my voice can be heard for 1s after I release the PTT, just in case I released it earlier by mistake (which I obviously sometimes do).
My log from tonight: http://pastebin.com/DvhnJQXp
For example, I would like to point you to these two links:
1. http://www.twitch.tv/vulkkswtor/b/451832514 - at 1h15min10s I say something and the last word - smoking - was cut off on my stream, but was clearly produced and heard on Mumble)
2. http://www.twitch.tv/vulkkswtor/c/2815091 - at 0min48s my line ends with a " have a good night", which was heard on Mumble, but was cut off on my stream.
Can someone, please, give me directions what options I could or should change.
Here is what I am using in the AUDIO tab and MICROPHONE NOISE GATE tab:
* Push To Talk Delay - 0 (I suspect this is the right one I need to change, but description says it is for general delay, not for delay of end of speech after I release the PTT Key)
* Force Microphone to Mono - UNCHECKED
* Use PTT - CHECKED (key is insert, same as my Mumble PTT key)
* Mic Time Offset - 0
* Enable Noise Gate - UNCHECKED
* Attacktime - 50
* Hold Time - 200
* Release Time - 150
I could not understand to full the options in the last tab, but I don't also need to use noise reduction either.
I am using Push To Talk button. If any of these settings is related to the time delay for when sound cuts off after I release the PTT, then please tell me which one is it. For example, on Mumble I am using 1000ms "Hold Time" so my voice can be heard for 1s after I release the PTT, just in case I released it earlier by mistake (which I obviously sometimes do).
My log from tonight: http://pastebin.com/DvhnJQXp