Question / Help Is there a way to output the signal then push it through a JustAddPower?

[ericarthurc]

We currently are using a PC to stream through OBS, and was wondering if I can output the stream from the computer to a JustAddPower. That is an IP over HDMI sender then we have six TVs throughout the building that have the receivers.

I haven't been able to figure it out, and there isn't much information on this. Thanks in advance!

 

[Narcogen]

If you connect whatever the HDMI input of that device is to an HDMI plug on the computer you're using to run OBS, you should be able to set OBS to use that device as a preview output. Right click the preview window, choose "Fullscreen Projector: Preview" and from the dropdown, choose the display device that is connected to the JustAddPower.

If your hardware allows for sending audio to an HDMI port, you could conceivably set that device in OBS as your monitoring device, and then set monitoring to on for all the devices you want to have audio for on the JustAddPower device.

Never used that hardware, though, so I'm just spitballing.

 

[ericarthurc]

If you connect whatever the HDMI input of that device is to an HDMI plug on the computer you're using to run OBS, you should be able to set OBS to use that device as a preview output. Right click the preview window, choose "Fullscreen Projector: Preview" and from the dropdown, choose the display device that is connected to the JustAddPower.

If your hardware allows for sending audio to an HDMI port, you could conceivably set that device in OBS as your monitoring device, and then set monitoring to on for all the devices you want to have audio for on the JustAddPower device.

Never used that hardware, though, so I'm just spitballing.

Thanks for the reply; I will give it a try.

 

[ericarthurc]

If you connect whatever the HDMI input of that device is to an HDMI plug on the computer you're using to run OBS, you should be able to set OBS to use that device as a preview output. Right click the preview window, choose "Fullscreen Projector: Preview" and from the dropdown, choose the display device that is connected to the JustAddPower.

If your hardware allows for sending audio to an HDMI port, you could conceivably set that device in OBS as your monitoring device, and then set monitoring to on for all the devices you want to have audio for on the JustAddPower device.

Never used that hardware, though, so I'm just spitballing.

So this actually worked; thank you! In the past we tried this with an AMD 7700 and it didn't work.. but I just tried it with a new AMD 580 graphics card and it works perfectly.

Thank you!

 

[Narcogen]

You're welcome!