How to record in Stereo using Behringer UCA202.

[fogroach]

Hi all,
I purposely bought the Behringer UCA202 so that I could record/stream with a stereo signal, as I send a stereo signal from my mixer. I have set up this device as the mic/aux on OBS Studio but I still only see a single channel on the audio view, so it is only recording in Mono.
What am I doing wrong here? If I go to the cog settings of that audio it makes no change if i select or deselect the mono box. Is this a limitation with my onboard soundcard perhaps. (I notice when I use the default laptop mic on my laptop it comes up as a stereo sginal on OBS).

 

[fogroach]

Got it!
It was in the hardware options of the Berhinger USB device in Control Panel. It was set to one channel and not 2. Hope this helps anyone else!

 

[varnaip]

I just registered to the forum to say thank you! I'll try it tomorrow, I've been struggling with this for a while :D
Probably I'll have my test results sooner, but: was it still actually two separate channels? once I got it to recognize as stereo but it was just still a mono signal duplicated to 2 channels.