Hey folks!
I have a serious clipping problem with OBS what i can't understand.
The setup consists of a shure wireless Headset, that goes into a shure Receiver (not clipping) what goes directly into a dante Avio (not clipping) which then again goes into the streaming Win 10 PC. With Dante Via the signal gets routed into OBS. In OBS i need to gain (with the OBS "Gain"-filter) the signal, because its too weak. At this point i can produce a clipping, that i don't see in the output-meter of the audio-mixer, because its afaik an output-meter. Therefore it is just possible to control clipping by hearing.
Is there a way in OBS to see the input-meter of an input? Or even a master-output-meter?
best wishes
I have a serious clipping problem with OBS what i can't understand.
The setup consists of a shure wireless Headset, that goes into a shure Receiver (not clipping) what goes directly into a dante Avio (not clipping) which then again goes into the streaming Win 10 PC. With Dante Via the signal gets routed into OBS. In OBS i need to gain (with the OBS "Gain"-filter) the signal, because its too weak. At this point i can produce a clipping, that i don't see in the output-meter of the audio-mixer, because its afaik an output-meter. Therefore it is just possible to control clipping by hearing.
Is there a way in OBS to see the input-meter of an input? Or even a master-output-meter?
best wishes