vhs to digital

I’ve been trying to transfer videos from an old Panasonic Palmcorder to my PC, every time I press play on the device, I’m able to see a short part of the video followed by a blue screen display. These are the steps I’ve conducted so far: 1st method: I used a cheap RCA to HDMI converter + HDMI...

To those wiser than I (especially in digitizing VHS tapes): Newbie to OBS here. In the middle of trying different digitizing methods for hundreds of VHS tapes. Now trying OBS with my Elgato HD 60X and i've noticed the first few seconds features an overlay showing "AV/NTSC" in the upper right...

I'm trying to convert from VHS to MP4 (using EXT 1 / AV 1 port), but can't figure out what's the issue here. I have followed these instructions: https://www.youtube.com/watch?v=G2CIEE8kjSU What am I doing wrong here?

Hey gang. I'm digitizing VHS tapes played on a JVC VCR through Elgato Video Capture via OBS 30.1.2 on Windows 10 Home. I've noticed that enabling Yadif 2x deinterlacing, I see a lot of dropped frames, resulting in "stuttering" video, especially when a camera is panning left-to-right. Here is...

Good morning, I have been successfully transferring VHS footage through OBS, but suddenly it stopped transferring the audio. :'( Does anyone have ideas for troubleshooting this? I don't think I would have accidentally changed any settings, and I triple checked to make sure everything is set up...

Hi, Now that A.I. is everywhere, I thought to now finally get my VHS videos to the PC. What would you consider the best method to do this? Many THX for suggestions. PS: I have an old Hauppauge HD PVR 1212 is this useful for this project?

I'm currently trying to digitize some old VHS-C tapes I have, and my setup is as follows: I have the VHS-C tapes in a VHS adapter playing through an old VHS machine, which is then connected via a series of adapters and eventually a video capture card into my laptop. I can usually get the video...

Hi all, I am trying to digitalize all of my family's old Hi8 tapes, and I am following the guide below on Youtube. However, I run into a problem that I can't find that others have had. When adding my video capture device (the old family sony handycam) it previews the video dismantled into 4...

My Elgato capture device ( I transfer VHS tapes to digital ) is just not showing on my Mac when I go add a source, I am running Catalina , OBS is up to date & works perfectly well on Windows. I have deleted all settings, done a fresh install & still no good. I would be very grateful for any help.