Switching scenes in multiview now changes the preview output not live after updating to v26...?

W

WrecklessRay

New Member
So, prior to updating to v26, we were able to run the multiview in full screen and see all the inputs and change the program out based on what we click.
After updating to V26 - it now changes the preview output not the live output.
Have already been in to the settings and check that "Multiview: click to change scenes" is enabled - and it is. Have also tried toggling this settings.
It also has the same effect in "windowed" multiview.

Tried this on 2 pc's now and same effect..... Is this a bug?
 
Banyarola

Banyarola

Active Member
I don't use that too often but I just tried it and mine works fine.
I click on a scene and it goes to preview and also to program at the same time...
 
L

lebaston100

Member
The behaviour changes btw depending if you have studio mode enabled (multiview clicks change the preview, double click switches to programm if enabled) or disabled (multiview clicks change the program+preview).
 
W

WrecklessRay

New Member
lebaston100 said:
The behaviour changes btw depending if you have studio mode enabled (multiview clicks change the preview, double click switches to programm if enabled) or disabled (multiview clicks change the program+preview).
Click to expand...
Hmm, ok..... hadn't realised that - is that noted some where? Might have just missed that one as we do use studio mode a far bit.... Also the general settings menu seems to suggest scenes will be changed on click... doesnt say anything about double click in studio mode.... again might have missed something....
 
L

lebaston100

Member
Not sure if that's explicitly mentioned anywhere. The "Transition to scene when double-clicked" is a menu point under "General" -> "Studio Mode". Doesn't say it anywhere that i know of that the double click also works in the multiview.
I agree that the "Click to switch between scenes" is a bit missleading when studio mode is active
 
H

Hexvid

New Member
Hi, I've recently installed OBS v.27 on an old 2011 13" MBP 4GB RAM under High Sierra, for a theatre project that requires switching live camera with computer content/video. All very low budget, so many thanks to OBS!
I was able to get a vintage Blackmagic Intensity Shuttle to interface the MBP with the camera. A 2011 Samsung SMX F500-BP, 720x564.
For my purposes, Studio mode is ideal.
All good & well, but I was unable to toggle between scenes by double-clicking.
So, lebaston100, you now have officially saved my day by pointing me to OBS Preferences > General > "Transition to scene when double-clicked"
I can confirm this also works fine in Multiview, a KISS (keep it simple safe) method much preferred by my performers, who have to keep their heads and hand free for purely performing.
So: KUDOS to you!
 
You must log in or register to reply here.
Top