Settings got changed, but I didn't change them

A

AutisticBravoCharlie

Member
Had an interesting issue sometime between 2025-12-07 11:29 and 2025-12-14 10:12. My encoder got switched from hardware to software. I noticed the computer a little sluggish but didn't notice it was because the CPU was at 100% for the entire broadcast. Frame rate was about 1fps - suboptimal, as you can imagine.

The strange thing is you can see where I changed it back:

Code: 
2025-12-14 09-47-26.txt:11:36:40.590: Settings changed (outputs)

But this doesn't appear anywhere else so I don't know how it got changed in the first place. Any suggestions for preventing this from happening again would be appreciated. Full log: https://pastebin.com/He6BjnzH
 
Your encoder will never change on its own, the most likely explanation is that you accidentally changed it and didn't realize.
 
It happened again, this time with streaming settings. As before, you can see in the logs where I change it back, but not where the original change was made.

Now on 32.0.4. No updates between the last successful stream and the first failed one.
 
You must log in or register to reply here.
Back
Top