Rode Rodecaster Pro 2 - Main Output Channel No Audio

[hundleton1]

HI All, I have a new Rodecaster Pro 2 and there seems to be something funky with OBS and the main Audio channel.

Device has 2 IO channels with Main and Chat. OBS pickups no Audio from the main channel at all regardless of any setting, If I set it to the chat channel it works fine.

This means you cant use the typical setup with Mix Minus.

II have confirmed in other programs the Audio channel is working fine.

Any ideas ?

 

[hundleton1]

Just an update from Rode they say Main output is multitrack and may not work with all software. This is likely something that could be resolve OBS side I guess but would not know where to start.

 

[croharp]

Thanx God for your post, finally I can use OBS, I was try everything but not to change to chat channel. Now I use beta firmware 1.0.6 and I can put chat channel to main mix without mix minus and I can route mix minus to usb 1, usb 2 or bluetooth so everything work fine.

 

[Ctonef15]

HI All, I have a new Rodecaster Pro 2 and there seems to be something funky with OBS and the main Audio channel.

Device has 2 IO channels with Main and Chat. OBS pickups no Audio from the main channel at all regardless of any setting, If I set it to the chat channel it works fine.

This means you cant use the typical setup with Mix Minus.

II have confirmed in other programs the Audio channel is working fine.

Any ideas ?

Unfortunately, I'm in the same boat and have spent about 20hrs trying to figure out what's wrong. The worst part is, I had my RodeCasterPro-ii working prefectly w obs up until the latest RCP-2 firmware update. I use the RCP-2 and obs to record guitar (instrument plugged to fader-1 input) and an MP3 playing on my laptop captured to the fader-2 input via USB-1. This configuration worked fine for recording the guitar, MP3 and video capture so as to produce a video for posting. After the RCP-2 firmware update, I can get the MP3 recorded ok (good signal on RCP-2 and in obs) but can't get the guitar input into obs (good guitar signal going into RCP-2 but nothing in obs). I've manipulated every possible combination of audio settings for obs, for RCP-2 and for the laptop but i've thus far been unable to get a simple guitar signal from RCP-2 into obs...this is after multiple uninstall/reinstalls, firmware/driver updates etc....wish i could be more help but i will be monitoring this thread and the thread i posted earlier today on same subject.