I'm just starting my investigation so I don't know exactly how to recreate this problem, nor have I been able to capture logs, so I know I have work to do. I just wondered if anyone else is experiencing this problem. I turned on the NDI output for the first time this morning. After a few minutes, my cursor started to spin, and OBS became unresponsive. The recording continued, and the stream continued, however, I was unable to interact with the user interface to change scenes, etc. Is this a known issue? My CPU utilization was low, around 3.5%, and I was not dropping frames, however, OBS acted like it was busy, somehow, and unable to service the UI. Once the cursor started to spin, it did not stop until I "force quite" OBS after a minute or two.
MacOS Catalina cursor spins while using NDI output tool
- Thread starter jqjrvpex
- Start date