I’ve searched the forums for this specific issue prior to asking, so if it’s been discussed ad nauseum, I apologize. I simply can’t find the answer.
I have a logo file that I’m trying to lay over some scenes. The logo page is set correctly to have the required transparency in the negative space, while leaving the lettering in bold color.
When I lay this over another source (e.g. my webcam or dslr) the top logo layer will not remain fully bold. I’ve moved the transparency settings, in the filter color correction, to every possible configuration, and still can’t stop getting a 50/50 split between both layers. Meaning, my logo layer is still allowing the image from beneath it to be visible enough to make the overlayed logo lettering illegible.
If there is a solution, I would welcome the tutorial. My firmware is up to date.
I have a logo file that I’m trying to lay over some scenes. The logo page is set correctly to have the required transparency in the negative space, while leaving the lettering in bold color.
When I lay this over another source (e.g. my webcam or dslr) the top logo layer will not remain fully bold. I’ve moved the transparency settings, in the filter color correction, to every possible configuration, and still can’t stop getting a 50/50 split between both layers. Meaning, my logo layer is still allowing the image from beneath it to be visible enough to make the overlayed logo lettering illegible.
If there is a solution, I would welcome the tutorial. My firmware is up to date.