Have 3 Scenes How To Keep Full Projector Mode Active After Scene Change?

[Jibun no Kage]

Have 3 Scenes How To Keep Full Projector Mode Active After Scene Change?

If I select scene 1, have to again, select full projector mode and select monitor again
If I select scene 2, have to again, select full projector mode and select monitor again
If I select scene 3, have to again, select full projector mode and select monitor again

This makes no sense to me, if I setup full projector mode and select a monitor, for a scene it should remember that configuration, no?

If this is actually to design behavior, how did I change it, so once a scene has a full projector mode set to a specific monitor, it is remembered, when I cut bac to that very same scene?

 

[AaronD]

Sounds like you're sending a specific scene to the projector, in which case yes, you do have to change that manually and explicitly. If you right-click the Program window instead, you can send *that* to the projector, and then it follows the main output.

 

[Jibun no Kage]

Ah... from program... ok. How can I automate this? So once set it is always set? Need OBS to start up and just be correct. I have to do this so the 'team' does not have to know anything about OBS or such. Just power up the system, and everything is already set.

They don't even have to know the interface, since scene cuts are done from an external device, i.e. a Stream Deck. We are dealing with volunteers that will have no training to speak of and have absolutely no understanding of OBS.

 

[AaronD]

There's a setting on the General tab, to remember projectors.

However, if someone closes the projector window before the main window, then it'll remember *that*. Probably not what you want. The only solution I know there, is to drill into them to NEVER "X-out" of OBS! Or right-click the taskbar, or any other method to close it. Always and only use the Exit button in the Controls dock.