Fade transition glitch when switching scenes fast

nzobs

New Member
Has anyone else noticed that when you switch between different scenes and you interrupt the transition (ie. you switch to another scene), the output gets a bit messy?

To replicate:
* create at least three scenes - A, B & C
* select Transition to "Fade", and make it long - say 2000ms to see it clearly (the issue occurs on short transitions too, but it's harder to notice)
* Select scene A
* Select scene B, but half way through the transition select scene C
* notice that when you interrupted the A-B transition - ie. the moment you selected scene C, the output immediately cut back to scene A and started transitioning to scene C.

This happens when you accidentally select the wrong scene, and then quickly change it to the right one - the "CUT" back to the original scene is very visible. I would expect the correct behaviour to be either:
* finish transition A-B before transitioning B-C
* disallow selecting next scene until the current transition is over
* perhaps allow to cut directly into the selected transition with double-click (I might be overthinking this though)

Anyone else noticed this?
 
Top