I have my Mac audio going out of the computer into a Behringer Xenyx 802 mixer via an Behringer u-phoria UM2 audio interface, and then back into the computer through that same audio interface.
I’m doing a mix minus for recording interviews, and the exact setup is I have
dynamic microphone connected via xlr to level1
level 3 has a dual 1/4 TS male todual rca male connected to the output of the interface
A 1/4 TS is plugged into FX send into the mic/line one of the interface.
The audio only cracks on the guest, and it only happens if I’m recording or streaming, when I do a call and don’t record, the audio is fine.
Is the signal unstable?
Is my Mac just unable to do all that processing with an i5 processor?( it rarely hits 50% cpu when streaming/recording)
Please help.
I’m doing a mix minus for recording interviews, and the exact setup is I have
dynamic microphone connected via xlr to level1
level 3 has a dual 1/4 TS male todual rca male connected to the output of the interface
A 1/4 TS is plugged into FX send into the mic/line one of the interface.
The audio only cracks on the guest, and it only happens if I’m recording or streaming, when I do a call and don’t record, the audio is fine.
Is the signal unstable?
Is my Mac just unable to do all that processing with an i5 processor?( it rarely hits 50% cpu when streaming/recording)
Please help.
Last edited: