Question / Help Colorspace issue with a Datapath VisionDVI-DL

[EDGAR_SEC]

Hey guys,

I decided to give OBSMP a test run and ran into an issue where no matter which combinations of settings I've tried on both driver and OBSMP side, the color capture is always messed up.

Here is what I'm getting in OBSMP's preview window and when streamed out:

Interestingly enough, if I open up Datapath's direct capture monitoring at the same time, the colors are correct in that viewer:

I've literally tried every combination of NV12/RGB/YUV/etc and 709/601/etc with no change. This issue occurs in both 32 and 64 bit versions of OBSMP. The colors are perfectly accurate when using OBS1 though. Any ideas?

Here is my log: http://pastebin.com/htaTzsHL

Thanks!

 

[EDGAR_SEC]

Any suggestions? Oddly enough, my Micomsoft card isn't even recognized in OBSMP either.

 

[Draco]

Using NV12 just doesn't work right. This is confirmed with both my VisionRGB E1s and E2.

I always used XRGB and flip vertically.

....oh, but wait, you said you tried every combination? That's very odd then. Maybe the DL is somehow different in some way over the E1s/E2? o_O

https://www.dropbox.com/s/xbrgoec8djm7dot/Screenshot 2016-02-04 21.04.26.png

Can't test the Micomsoft card as I don't have one of those... yet. ;)

---------

I also just noticed how old this thread is... whoops! Oh well. :)