thebluescarecrow
Member
You cannot bring any video content into your live stream with any kind of professionalism.
Create new Scene.
Create new source for the Scene.
Browse for the content.
Click on the content.
Highlight the new Scene and nothing appears on the preview screen.
Transition to it and it appears as a small square in the upper left of the Program screen.
Highlight the Scene again and the video will show up in the upper left of the Preview Screen.
Right click on the video... click on Transition... Stretch to fit Screen.
Click on Transition again to make it appear in the Program window.
At this point, you are already into the video about 10 seconds and your audience is wondering WTF is going on.
Not done yet.
Now you have to set the volume.
The talent still cannot hear the audio track.
Click on the audio Track Settings... Advanced Audio Properties
Under Audio Monitoring, click on Monitor Off... then click on Monitor and Output.
The audio is already streaming out, but this audio has to go through your board as a Mix Minus, because there slight delay which causes an echo.
At this point you are finished with your Scene; onward to the next Scene and through all these steps again.
And even after I did all this, there were still a couple of clips that didn't play... just the audio.
This is so stupid, I can't even begin to tell you.
Still on 25.0.8 and no fixes in sight.
Create new Scene.
Create new source for the Scene.
Browse for the content.
Click on the content.
Highlight the new Scene and nothing appears on the preview screen.
Transition to it and it appears as a small square in the upper left of the Program screen.
Highlight the Scene again and the video will show up in the upper left of the Preview Screen.
Right click on the video... click on Transition... Stretch to fit Screen.
Click on Transition again to make it appear in the Program window.
At this point, you are already into the video about 10 seconds and your audience is wondering WTF is going on.
Not done yet.
Now you have to set the volume.
The talent still cannot hear the audio track.
Click on the audio Track Settings... Advanced Audio Properties
Under Audio Monitoring, click on Monitor Off... then click on Monitor and Output.
The audio is already streaming out, but this audio has to go through your board as a Mix Minus, because there slight delay which causes an echo.
At this point you are finished with your Scene; onward to the next Scene and through all these steps again.
And even after I did all this, there were still a couple of clips that didn't play... just the audio.
This is so stupid, I can't even begin to tell you.
Still on 25.0.8 and no fixes in sight.