tobisk
New Member
I decided against using the Decklink card to output key/fill and decided to use a decklink to input in OBS and then another decklink to output the program feed to the venue and also use OBS for Recording/Streaming.
Setup is:
- I get audio from the venue mixer from my Video Mixer via SDI (or via a soundcard on the OBS PC)
- I need to output some playback audio to the venue mixer of videos that are played in OBS
However this presents with new challenges:
- I need audio coming in from the Venue to be recorded and sent to the stream
- I need audio from (some) Video sent back to the venue mixer (which might or might not send this audio back to me) and recorded and sent to the stream
- I need to not send the sound signal from the venue mixer back to the venue mixer (no feedback loops)
- I want a possibility to monitor the audio mix as it is recorded or sent to the stream.
is this possible with OBS?
Probably I can set audio sources that
- should go only to Recording as "No Monitoring"
- should go to the venue only as "Monitor Only"
- should go to venue and recording as "Monitoring and Output"
However, how do I then monitor the MIX going to the output?
Can I assign the output to a separate soundcard?
So I have a matrix:
Setup is:
- I get audio from the venue mixer from my Video Mixer via SDI (or via a soundcard on the OBS PC)
- I need to output some playback audio to the venue mixer of videos that are played in OBS
However this presents with new challenges:
- I need audio coming in from the Venue to be recorded and sent to the stream
- I need audio from (some) Video sent back to the venue mixer (which might or might not send this audio back to me) and recorded and sent to the stream
- I need to not send the sound signal from the venue mixer back to the venue mixer (no feedback loops)
- I want a possibility to monitor the audio mix as it is recorded or sent to the stream.
is this possible with OBS?
Probably I can set audio sources that
- should go only to Recording as "No Monitoring"
- should go to the venue only as "Monitor Only"
- should go to venue and recording as "Monitoring and Output"
However, how do I then monitor the MIX going to the output?
Can I assign the output to a separate soundcard?
So I have a matrix:
| IN belog / out right | Out to Venue Mixer | Out to Recording/Stream | Out to Local Monitor/Headset |
| Venue Audio Stereo Signal via SDI or Soundcard | NO | YES | YES |
| Video/ Audio Playbacks from Clips within OBS | YES | Yes, If not part of signal coming back from venue | Yes, If not part of signal coming back from venue |
| Audio Signals from Cameras from my ATEM video mixer via SDI out and Decklink Monitor in in OBS | NO | YES | YES |