Question / Help 2 Logitec Cameras 90- 922X Problems where are properties?

[ralphiedee]

Ok I have a MacBook Pro using a powered USB hub (4) 1. DJ controller_2. Logitec 920 _3.Logitec 922X _4th empty

I saw a video on you tube explaining that when using 2 logitec cameras they have to be manually set each cameras properties. But I cannot find where the camera properties are. I get as far as Control clicking properties but don't see where I can adjust the camera manually. Any help?

 

[ralphiedee]

OK figured out I was looking at a video which was using a pc, so NOW I found that Logitec had an app that manually lets you adjust settings for each camera but it is no longer supported so I downloaded Webcam Settings which does the same thing , followed easy instructions and now both cameras ( along with my Facetime camera work but now when I run my Dj software the audio stutters. Will this show up in the OBS logs if so please advize as I need to figure this out before show time tomorrow

 

[Zeros.81]

Don't connect the Audio device to the same BUS where you connect the Webcams. You should distribute your USB devices between your avaiable USB Buses

How to check which USB devices are connected to specific hubs / buses on your system.

Applies to: All products Where possible, we recommend using your Novation products on their own internal USB hubs/busses. To check whether your devices are on separate USB buses please follow these...

support.novationmusic.com

 

[ralphiedee]

Ah yes thx

 

[ralphiedee]

Looking further I moved my audio to the other bus I need to run it to make sure I don't have glitches but to the original problem I have ,running two Logitec cameras I STILL cannot get both to work correctly only way is to run one on the 352x288 and then both work I even installed WebCam Settings app and still have the problem. Anyone?